Jet Cat engine
 
P20-SE Special Edition Turbine Complete Price: $2,795.00
 

Now with internal kerosene start. No propane needed!

Max Thrust: 5.5 lbs
Engine Weight: 0.8 lbs
Diameter: 2.34"
Length: 7"
RPM Range: 85,000 to 245,000
Max Temp: 690C
Fuel Rate at Full Power: 3 fl oz per minute

 


 

Jet Cat P60-SE Special Edition Price: $2,395.00
 

JetCat P60-SE SPecial Edition Turbine complete with starter includes:
 

  • Jet-tronic ECU (fuel control electronics)

  • GSU (Display and Programmer)

  • LED I/O board

  • Miniature fuel pump

  • Electronic starting gas valve

  • Electronic Fuel valve

  • Fuel tubing, tubing connector set, filters, and cable set

  • 2 cell, 2500mA LiPoly battery pack

  • Starting gas tank

  • Turbine mounting clamp, RamTec compatible

  • Detailed instruction manual

Thrust: 13 LB @ 165,000 RPM
 
Weight: 1.87 LB, incl. starter
 
Diameter: 3.25 inches
 
RPM Range: 50,000 - 165,000
 
Exhaust gas temp.: 580C -690C
 
Fuel consumption: 8 oz per/min at full power
 
Fuel: Jet A1, 1-K kerosene
 
Lubrication: approximately 5% synthetic turbine oil in the fuel
 
Maintenance interval: 25 hours
 

 
 
JetCat P80-SE turbine Price: $2,195.00
 

Introducing the new JetCat P80-SE with more POWER and enhanced reliability.

The P80-SE continues our extreemly successfull P80 engine. The new design of the P80-SE incorporates an optimized compressor/diffusor-system, resulting in higher engine performance and reliability.

The engine follows throttle commands almost without delay. In addition to the outstanding features of or ECU V6.0, the new ECU V6.3 has an auto power down function built in, which allows to switch off the engine power supply (--> receiver off) before the engine cool down sequence has been finished. In this case the ECU will stay powered on, finish the cool down sequence and then auto power down itself.

JetCat P-80-SE turbine complete with starter includes:
 
  • Jet-tronic ECU (fuel control electronics)
  • GSU (Display and Programmer)
  • LED I/O board
  • Miniature fuel pump
  • Electronic starting gas valve
  • Electronic Fuel valve
  • Fuel tubing, tubing connector set, filters, and cable set
  • 2 cell, 2500mA LiPoly battery pack
  • Starting gas tank
  • Turbine mounting clamp, RamTec compatible
  • Detailed instruction manual
     
    Thrust: 22 LB @ 125,000 RPM
     
    Weight: 2.9 LB, incl. starter
     
    Diameter: 4.4 inches
     
    RPM Range: 35,000 - 125,000
     
    Exhaust gas temp.: 580C -690C
     
    Fuel consumption: 9 oz per/min at full power
     
    Fuel: Jet A1, 1-K kerosene
     
    Lubrication: approximately 5% synthetic turbine oil in the fuel
     
    Maintenance interval: 25 hours
     
    P80-SE Thrust Chart
     
    RPM Thrust
    35,000 0.8
    85,000 8.0
    93,000 10.0
    101,000 12.5
    110,000 15.0
    117,000 17.0
    118,000 18.0
    120,000 20.0

    125,000

    22.00

    The values are approximate and can vary slightly from engine to engine.
    Values at Standard Temperature and Pressure.
     
     

     

 
JetCat P100RX turbine Price: $2,595.00


The future is here! Jetcat P100-RX includes our state of the art V10 ECU. Single fuel and cable connection to the engine. No external solenoids! Internal kero start and exhaust gas temperature probe. New smart fuel pump with easy mount aluminum case. Includes 9.9V LiFe battery. A123 compatible! Comes with everything you need to install into your plane.

� Compact outline and form factor
� Internal kerosene start
� Internal EGT sensor!
� Internal solenoids, only one fuel connection to the engine
� New us-system� fuel pump
� Single wiring connection from ECU to engine
� New miniature/lightweight ECU V10.0
� Battery: 2-cell LiPo or optional 3-cell LiFe (e.g. A123)

Max Thrust: >22 lbs
Engine Weight: 2.38 lbs
Diameter: 3.78"
Length: 9.55"
RPM Range: 42,000 to 152,000
Max Temp: 730C
Fuel Rate at Full Power: 12 fl oz per minute
 
JetCat P140-RX turbine Price: $3,295.00
 

JetCat P-120-SX turbine complete with starter includes:
 

  • Jet-tronic ECU (fuel control electronics)

  • CAD designed and machined from billet compressor wheel

  • Internal kerosene starting plug for single fuel operation. Fast startup!

  • GSU (Display and Programmer)

  • LED I/O board

  • Miniature fuel pump

  • Electronic starting gas valve

  • Electronic Fuel valve

  • Fuel tubing, tubing connector set, filters, and cable set

  • The future is here! Jetcat P140-RX includes our state of the art V10 ECU. Single fuel and cable connection to the engine. No external solenoids! Internal kero start and exhaust gas temperature probe. New smart fuel pump with easy mount aluminum case. Includes 9.9V LiFe battery. A123 compatible! Comes with everything you need to install into your plane. 32lbs of thrust!

    � Compact outline and form factor
    � Internal kerosene start
    � Internal EGT sensor!
    � Internal solenoids, only one fuel connection to the engine
    � New us-system� fuel pump
    � Single wiring connection from ECU to engine
    � New miniature/lightweight ECU V10.0
    � Battery: 2-cell LiPo or optional 3-cell LiFe (e.g. A123)

    Max Thrust: >32 lbs
    Engine Weight: 3.5 lbs
    Diameter: 4.37"
    Length: 12.9"
    RPM Range: 33,000 to 125,000
    Max Temp: 710C
    Fuel Rate at Full Power: 17.2 fl oz per minute

JetCat P180-RX turbine Price: $3,995.00

 

The future is here! Jetcat P180-RX includes our state of the art V10 ECU. Single fuel and cable connection to the engine. No external solenoids! Internal kero start and exhaust gas temperature probe. New smart fuel pump with easy mount aluminum case. Includes 9.9V LiFe battery. A123 compatible! Comes with everything you need to install into your plane.

� Compact outline and form factor
� Internal kerosene start
� Internal EGT sensor!
� Internal solenoids, only one fuel connection to the engine
� New us-system� fuel pump
� Single wiring connection from ECU to engine
� New miniature/lightweight ECU V10.0
� Battery: 2-cell LiPo or optional 3-cell LiFe (e.g. A123)

Max Thrust: >40 lbs
Engine Weight: 3.5 lbs
Diameter: 4.37"
Length: 12.9"
RPM Range: 33,000 to 125,000
Max Temp: 730C
Fuel Rate at Full Power: 20.6 fl oz per minute

 

 
 
JetCat P200 turbine Price: $5,195.00
 
JetCat P-200 turbine comes complete with HEAVY DUTY starter and includes:
  • Jet-tronic ECU (fuel control electronics)
  • GSU (Display and Programmer)
  • LED I/O board Miniature fuel pump
  • Electronic starting gas valve
  • Electronic Fuel valve
  • Fuel tubing, tubing connector set, filters, and cable set
  • 2 cell, 3800mA LiPoly battery pack
  • Starting gas tank
  • Turbine mounting clamp
  • Detailed instruction manual
    Thrust: 52 lbs @ 112,000 RPM
     
    Weight: 5 LB
     
    Diameter: 5.12 inches
     
    RPM Range: 32,000 - 110,000 RPM
    Exhaust gas temp.: 580C-720C
     
    Fuel consumption: 24 oz per/min at full power
     
    Fuel: Jet A1, 1-K kerosene
     
    Lubrication: approximately 5% synthetic turbine oil in the fuel
     
    Maintenance interval: 25 hours